Welcome to program SCHED. Version: Release of 18 Sept. 2003 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. ** NEW ** Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). TPINI: Reading tape initialization information from SCHED input file. RDSET: Reading setup file: bg139_1.18cm RDSET: Reading setup file: bg139_2.18cm STREAD: Reading station catalog: /home/filehost/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/filehost/cwalker/sched/catalogs/locations.dat SCHIN: Found 316 input scans. SCHIN: * Automatic tape allocation requested at: Sc Hn Nl Fd La Pt Kp Ov Br Mk SRREAD: Reading source catalog: /home/filehost/cwalker/sched/catalogs/sources.vlba GETFREQ: Reading frequency file: /home/filehost/cwalker/sched/catalogs/freq.dat SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine SETTPS: Tape is being kept running through short gaps between scans. Add TPSTART to the SUMITEM list to see details. MINPAUSE and PRESTART may be used to adjust. Remember MINPAUSE is multiplied by the speed up factor. WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation are being removed from scans when the source is below the antenna pointing limits. SCHOPT: There will be 316 output scans ( 1 - 316) from 16/00:00:01 to 16/23:55:35 SUMOPE: Writing summary file bg139a.sum OMSOUT: Writing OMS file bg139a.oms FLAGS: Writing apriori flagging file bg139a.flag Processing VLBA_SC Processing VLBA_HN Processing VLBA_NL Processing VLBA_FD Processing VLBA_LA Processing VLBA_PT Processing VLBA_KP Processing VLBA_OV Processing VLBA_BR Processing VLBA_MK