Welcome to program SCHED. Version: NRAO internal release of 4 October 2004 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. ** NEW ** Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). TPINI: Reading tape initialization information from SCHED input file. RDSET: Reading setup file: vw43a-h2o.set RDSET: Reading setup file: bi28geo.set SRREAD: Reading source catalog: Program_input WARNING: An unnamed source was found in the source catalog: Program_input There may be an extra '/' somewhere. STREAD: Reading station catalog: /home/filehost/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/filehost/cwalker/sched/catalogs/locations.dat SCHIN: Found 751 input scans. SCHIN: * Automatic tape allocation requested at: Sc Hn Nl Fd La Pt Kp Ov Br Mk SRREAD: Reading source catalog: /home/filehost/cwalker/sched/catalogs/sources.vlba GETFREQ: Reading frequency file: /home/filehost/cwalker/sched/catalogs/freq.dat SHORTN: WARNING - Source names longer than 8 characters used. Mark III correlators and geodetic software will have problems. SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation are being removed from scans when the source is below the antenna pointing limits. SCHOPT: There will be 751 output scans ( 1 - 751) from 35/12:13:26 to 35/22:10:48 SUMOPE: Writing summary file bi030c.sum OMSOUT: Writing OMS file bi030c.oms FLAGS: Writing apriori flagging file bi030c.flag Processing VLBA_SC Processing VLBA_HN Processing VLBA_NL Processing VLBA_FD Processing VLBA_LA Processing VLBA_PT Processing VLBA_KP Processing VLBA_OV Processing VLBA_BR Processing VLBA_MK