Welcome to program SCHED. Version: 8.10 Bug fixs and minor enhancements The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). SRREAD: Reading source catalog: Program_input RDSET: Reading setup file: bm261.set STREAD: Reading station catalog: /usr/local/sched/catalogs/stations.dat STREAD: Will read locations file /usr/local/sched/catalogs/locations.dat SCHIN: Found 50 input scans. TPINI: Using default tape initialization information. SRREAD: Reading source catalog: /usr/local/sched/catalogs/sources.vlba GETFREQ: Reading frequency file: /usr/local/sched/catalogs/freq.dat TWOHDSET: Using 2 head (MkIV) or 2 tape (VLBA) wide band mode. SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation or disk recording systems are being removed from scans when the source is below the antenna pointing limits. This behavior can be overridden using DODOWN. WRTMSG: Special message from routine SETTPS: Recording is being continued through short gaps between scans. Add TPSTART to the SUMITEM list to see details. MINPAUSE and PRESTART may be used to adjust. Remember MINPAUSE is multiplied by the speed up factor. SCHOPT: There will be 50 output scans ( 1 - 50) from 136/16:49:21 to 136/21:18:08 SUMOPE: Writing summary file bm291b.sum OMSOUT: Writing OMS file bm291b.oms VXWRT : Writing V E X file bm291b.skd FLAGS: Writing apriori flagging file bm291b.flag Processing VLBA_FD Processing VLBA_PT Processing VLBA_LA Processing VLBA_KP Processing VLBA_OV Processing VLBA_NL Processing VLBA_SC Processing VLBA_MK Processing VLBA_HN Processing VLBA_BR