Welcome to program SCHED. Version: 6.05 June 2006 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). RDSET: Reading setup file: i1828-h2o.set RDSET: Reading setup file: bi28geo.set SRREAD: Reading source catalog: Program_input STREAD: Reading station catalog: /home/arana/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/arana/cwalker/sched/catalogs/locations.dat SCHIN: Found 521 input scans. TPINI: Using default tape initialization information. SRREAD: Reading source catalog: /home/arana/cwalker/sched/catalogs/sources.vlba GETFREQ: Reading frequency file: /home/arana/cwalker/sched/catalogs/freq.dat CHKSC1: *** Shouldn't you be using AUTOTAPE=2 (VLBA stations, VLBA correlator). SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation or disk recording systems are being removed from scans when the source is below the antenna pointing limits. This behavior can be overridden using DODOWN. SCHOPT: There will be 521 output scans ( 1 - 521) from 114/08:35:26 to 114/14:35:07 SUMOPE: Writing summary file bi037d.sum CORSOC: **** WARNING **** Correlator output data rate limit exceeded. See summary file. OMSOUT: Writing OMS file bi037d.oms FLAGS: Writing apriori flagging file bi037d.flag Processing VLBA_SC Processing VLBA_HN Processing VLBA_NL Processing VLBA_FD Processing VLBA_LA Processing VLBA_PT Processing VLBA_KP Processing VLBA_OV Processing VLBA_BR Processing VLBA_MK