Welcome to program SCHED. Version: 6.05 June 2006 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). SRREAD: Reading source catalog: Program_input STREAD: Reading station catalog: /home/arana/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/arana/cwalker/sched/catalogs/locations.dat SCHIN: Found 990 input scans. TPINI: Using default tape initialization information. SCHIN: * Automatic tape allocation requested at: La Kp Nl Fd Ov Br Hn Sc Mk Pt RDSET: Reading setup file: /home/arana/cwalker/sched/setups/v7mm-128-4-2.set RDSET: Reading setup file: /home/arana/cwalker/sched/setups/v1cm-128-4-2.set GETFREQ: Reading frequency file: /home/arana/cwalker/sched/catalogs/freq.dat SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine SETTPS: Tape is being kept running through short gaps between scans. Add TPSTART to the SUMITEM list to see details. MINPAUSE and PRESTART may be used to adjust. Remember MINPAUSE is multiplied by the speed up factor. WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation or disk recording systems are being removed from scans when the source is below the antenna pointing limits. This behavior can be overridden using DODOWN. SCHOPT: There will be 990 output scans ( 1 - 990) from 57/00:50:29 to 57/16:47:21 SUMOPE: Writing summary file ba084c.sum OMSOUT: Writing OMS file ba084c.oms FLAGS: Writing apriori flagging file ba084c.flag Processing VLBA_LA Processing VLBA_KP Processing VLBA_NL Processing VLBA_FD Processing VLBA_OV Processing VLBA_BR Processing VLBA_HN Processing VLBA_SC Processing VLBA_MK Processing VLBA_PT