Welcome to program SCHED. Version: 6.05 June 2006 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). SRREAD: Reading source catalog: Program_input STREAD: Reading station catalog: /home/filehost/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/filehost/cwalker/sched/catalogs/locations.dat SCHIN: Found 172 input scans. TPINI: Using default tape initialization information. SRREAD: Reading source catalog: /home/filehost/cwalker/sched/catalogs/sources.vlba RDSET: Reading setup file: /home/filehost/cwalker/sched/setups/v4cm-256-8-2.set GETFREQ: Reading frequency file: /home/filehost/cwalker/sched/catalogs/freq.dat SHORTN: WARNING - Source names longer than 8 characters used. Mark III correlators and geodetic software will have problems. CHKSC1: *** Shouldn't you be using AUTOTAPE=2 (VLBA stations, VLBA correlator). SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation or disk recording systems are being removed from scans when the source is below the antenna pointing limits. This behavior can be overridden using DODOWN. SCHOPT: There will be 172 output scans ( 1 - 172) from 221/00:33:57 to 221/04:33:17 SUMOPE: Writing summary file bt093cd.sum OMSOUT: Writing OMS file bt093cd.oms FLAGS: Writing apriori flagging file bt093cd.flag Processing VLBA_SC Processing VLBA_HN Processing VLBA_NL Processing VLBA_FD Processing VLBA_LA Processing VLBA_PT Processing VLBA_KP Processing VLBA_OV Processing VLBA_BR Processing VLBA_MK