Welcome to program SCHED. Version: 6.02 July 2005 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). SRREAD: Reading source catalog: Program_input SCHIN: DOSTA specified as VL Some stations may be skipped. STREAD: Reading station catalog: /home/filehost/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/filehost/cwalker/sched/catalogs/locations.dat SCHIN: Found 36 input scans. TPINI: Using default tape initialization information. SCHIN: * Automatic tape allocation requested at: Sc Fd La Pt Kp Ov Mk SRREAD: Reading source catalog: /home/filehost/cwalker/sched/catalogs/sources.vlba RDSET: Reading setup file: /home/filehost/cwalker/sched/setups/v4cm-128-4-2-R.set RDSET: Reading setup file: /home/filehost/cwalker/sched/setups/v2cm-128-4-2-L.set GETFREQ: Reading frequency file: /home/filehost/cwalker/sched/catalogs/freq.dat SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine SETTPS: Tape is being kept running through short gaps between scans. Add TPSTART to the SUMITEM list to see details. MINPAUSE and PRESTART may be used to adjust. Remember MINPAUSE is multiplied by the speed up factor. SCHOPT: There will be 36 output scans ( 1 - 36) from 241/04:42:30 to 241/10:41:31 SUMOPE: Writing summary file be041.sum OMSOUT: Writing OMS file be041.oms FLAGS: Writing apriori flagging file be041.flag Processing VLBA_SC Processing VLBA_FD Processing VLBA_LA Processing VLBA_PT Processing VLBA_KP Processing VLBA_OV Processing VLBA_MK