Welcome to program SCHED.  Version:   6.05  June 2006

The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html
Unix users should set $SCHED to the base area where SCHED is installed.
Most run time messages will be in sched.runlog

Some useful commands to give now if running interactively:
   SCHedule=<filename>    :  Specify input file.
   PLOT                   :  Invokes uv, xy, rd, and uptime plotting.
   FREQLIST=lowF,highF    :  Make frequency list (MHz).  Then exit.
   EXIT                   :  Leave program.
   /                      :  End of inputs - run program (or EXIT).

SRREAD:  Reading source catalog: Program_input
RDSET:   Reading setup file: 3mm
RDSET:   Reading setup file: 7mm
RDSET:   Reading setup file: 1cm
RDSET:   Reading setup file: 6cm
RDSET:   Reading setup file: 2cm
RDSET:   Reading setup file: 4cm
STREAD:  Reading station catalog: /home/arana/cwalker/sched/catalogs/stations.dat
STREAD:  Will read locations file /home/arana/cwalker/sched/catalogs/locations.dat
SCHIN:   Found   144 input scans.
TPINI:   Using default tape initialization information.
SCHIN:   * Automatic tape allocation requested at: Sc Hn Nl Fd La Pt Kp Ov Br Mk
SRREAD:  Reading source catalog: /home/arana/cwalker/sched/catalogs/sources.vlba
GETFREQ: Reading frequency file: /home/arana/cwalker/sched/catalogs/freq.dat
WARNING:  See note in sched.runlog about frequency and bandwidth changes.

WRTMSG: Special message from routine CHKSC1:

CAUTION: You have set FREQ and/or BW for some scans but have not
changed them when switching to a new setup file.  These parameters do
not change from scan to scan unless forced.  It is possible that you
really did want them to change, perhaps to the value of the new setup
file.  Check what you have done carefully.  To cause SCHED to use the
setup file value, set FREQ=0 and/or BW=0.


SCHOPT:  First output scan will be number     1

WRTMSG: Special message from routine SETTPS:

  Tape is being kept running through short gaps between scans.
Add TPSTART to the SUMITEM list to see details.
MINPAUSE and PRESTART may be used to adjust.
Remember MINPAUSE is multiplied by the speed up factor.


WRTMSG: Special message from routine AUTODOWN:

  * Stations using automatic tape allocation or disk recording systems
    are being removed from scans when the source is below the antenna
    pointing limits.  This behavior can be overridden using DODOWN.

SCHOPT:  There will be   144 output scans (    1 -   144) from 116/09:56:22 to 116/21:56:09
SUMOPE:  Writing summary file bw086e.sum
OMSOUT:  Writing OMS file bw086e.oms
FLAGS:   Writing apriori flagging file bw086e.flag
 Processing VLBA_SC
 Processing VLBA_HN
 Processing VLBA_NL
 Processing VLBA_FD
 Processing VLBA_LA
 Processing VLBA_PT
 Processing VLBA_KP
 Processing VLBA_OV
 Processing VLBA_BR
 Processing VLBA_MK