Welcome to program SCHED. Version: 6.01 Release: Late March 2005 The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html Unix users should set $SCHED to the base area where SCHED is installed. Most run time messages will be in sched.runlog Some useful commands to give now if running interactively: SCHedule= : Specify input file. PLOT : Invokes uv, xy, rd, and uptime plotting. FREQLIST=lowF,highF : Make frequency list (MHz). Then exit. EXIT : Leave program. / : End of inputs - run program (or EXIT). TPINI: Reading tape initialization information from SCHED input file. SRREAD: Reading source catalog: Program_input STREAD: Reading station catalog: /home/arana/cwalker/sched/catalogs/stations.dat STREAD: Will read locations file /home/arana/cwalker/sched/catalogs/locations.dat SCHIN: Found 283 input scans. SCHIN: * Automatic tape allocation requested at: Sc Hn Nl Fd La Pt Kp Ov Br Mk Y SRREAD: Reading source catalog: /home/arana/cwalker/sched/catalogs/sources.vlba RDSET: Reading setup file: /home/arana/cwalker/sched/setups/v18cm-256-8-2.set GETFREQ: Reading frequency file: /home/arana/cwalker/sched/catalogs/freq.dat SHORTN: WARNING - Source names longer than 8 characters used. Mark III correlators and geodetic software will have problems. SCHOPT: First output scan will be number 1 WRTMSG: Special message from routine AUTODOWN: * Stations using automatic tape allocation or disk recording systems are being removed from scans when the source is below the antenna pointing limits. This behavior can be overridden using DODOWN. SCHOPT: There will be 283 output scans ( 1 - 283) from 100/17:26:19 to 101/04:08:27 SCHTIM: VLBA_SC averages more than 10 tape stops per hour. SCHTIM: VLBA_HN averages more than 10 tape stops per hour. SCHTIM: VLBA_NL averages more than 10 tape stops per hour. SCHTIM: VLBA_FD averages more than 10 tape stops per hour. SCHTIM: VLBA_LA averages more than 10 tape stops per hour. SCHTIM: VLBA_PT averages more than 10 tape stops per hour. SCHTIM: VLBA_KP averages more than 10 tape stops per hour. SCHTIM: VLBA_OV averages more than 10 tape stops per hour. SCHTIM: VLBA_BR averages more than 10 tape stops per hour. SCHTIM: VLBA_MK averages more than 10 tape stops per hour. SCHTIM: VLA1 averages more than 10 tape stops per hour. Tape synchronization on the VLBA correlator is better when the tape does not stop often. Parameters MINPAUSE and PRESTART may be used to encourage continuous tape motion. SUMOPE: Writing summary file bm220a.sum OMSOUT: Writing OMS file bm220a.oms FLAGS: Writing apriori flagging file bm220a.flag Processing VLBA_SC Processing VLBA_HN Processing VLBA_NL Processing VLBA_FD Processing VLBA_LA Processing VLBA_PT Processing VLBA_KP Processing VLBA_OV Processing VLBA_BR Processing VLBA_MK Processing VLA1