Welcome to program SCHED.  Version:   6.01  Release: Late March 2005

The manual is at http://www.aoc.nrao.edu/~cwalker/sched/sched/sched.html
Unix users should set $SCHED to the base area where SCHED is installed.
Most run time messages will be in sched.runlog

Some useful commands to give now if running interactively:
   SCHedule=<filename>    :  Specify input file.
   PLOT                   :  Invokes uv, xy, rd, and uptime plotting.
   FREQLIST=lowF,highF    :  Make frequency list (MHz).  Then exit.
   EXIT                   :  Leave program.
   /                      :  End of inputs - run program (or EXIT).

TPINI:   Reading tape initialization information from SCHED input file.
STREAD:  Reading station catalog: /home/filehost/cwalker/sched/catalogs/stations.dat
STREAD:  Will read locations file /home/filehost/cwalker/sched/catalogs/locations.dat
SCHIN:   Found    86 input scans.
SCHIN:   * Automatic tape allocation requested at: La Kp Nl Fd Ov Br Hn Sc Mk Pt
SRREAD:  Reading source catalog: /home/filehost/cwalker/sched/catalogs/sources.vlba
RDSET:   Reading setup file: /home/filehost/cwalker/sched/setups/v2cm-128-4-2.set
RDSET:   Reading setup file: /home/filehost/cwalker/sched/setups/v1cm-128-4-2.set
RDSET:   Reading setup file: /home/filehost/cwalker/sched/setups/v7mm-128-4-2.set
GETFREQ: Reading frequency file: /home/filehost/cwalker/sched/catalogs/freq.dat
SCHOPT:  First output scan will be number     1

WRTMSG: Special message from routine AUTODOWN:

  * Stations using automatic tape allocation or disk recording systems
    are being removed from scans when the source is below the antenna
    pointing limits.  This behavior can be overridden using DODOWN.


WRTMSG: Special message from routine SETTPS:

  Tape is being kept running through short gaps between scans.
Add TPSTART to the SUMITEM list to see details.
MINPAUSE and PRESTART may be used to adjust.
Remember MINPAUSE is multiplied by the speed up factor.


***** WARNING ****** Inadequate tape change time at
                     VLA1     on day  93 at 01:47:47
                     Please allow  15.00 minutes at single tape drive stations.
                     Schedule only has a   0.25 minute gap.
SCHOPT:  There will be    86 output scans (    1 -    86) from  92/16:28:01 to  93/03:32:35
SUMOPE:  Writing summary file ba071c.sum
OMSOUT:  Writing OMS file ba071c.oms
FLAGS:   Writing apriori flagging file ba071c.flag
 Processing VLBA_LA
 Processing VLBA_KP
 Processing VLBA_NL
 Processing VLBA_FD
 Processing VLBA_OV
 Processing VLBA_BR
 Processing VLBA_HN
 Processing VLBA_SC
 Processing VLBA_MK
 Processing VLBA_PT
 Processing VLA1
VLBACHG: **** Doing postpass at single drive site: VLA1
         **** Takes up to 22 minutes in addition to tape change time.
         **** Can be avoided by not stopping tape in preceeding pass.